Chapter 7: Setting Parameters
MSI/PLESSY
144
Teklogix 7035, 8255 & 8260 Terminals User Manual
Include Chk
If this parameter is enabled (set to “Y”), the check digit is included with the decoded
bar code data.
Size/Chars
See “Size/Chars” beginning on page 136.
7.6.3.11 MSI/PLESSY
1 Chk Digit
If this parameter is enabled (set to “Y”), it is assumed that the last digit is a
check digit.
Include Chk
If this parameter is enabled (set to “Y”), the check digit is included with the decoded
bar code data.
Size/Chars
See “Size/Chars” beginning on page 136.
7.6.3.12 D 2 of 5
Mod 10 Chk
If this parameter is enabled (set to “Y”), the Mod 10 check digit is calculated.
This calculation is the same as the Code 39 Mod 10 check digit.
1 Chk Digit Y
Include Chk N
Size/Chars »
MSI/PLESSY
Mod 10 Chk N
ITF Chk N
Include Chk N
Size/Chars »
D 2 of 5
To Next Page
Loading...