Appendix D: Radio Parameters
TRX7431 WaveLAN/IEEE 802.11 DS SS Radios
D-6
Teklogix 7035, 8255 & 8260 Terminals User Manual
802.IQ v1
Note: If you are using AirFortress Secure Client™ software, 802.IQv1 parame-
ters are not available.
When 802.IQ v1 is set to “Y”, the attached sub-menu of parameters is enabled.
Auto Radio Addr
If this parameter is enabled (set to “Y”), a request is sent to the network controller to
assign a radio address to the terminal radio.
If “Auto Radio Addr” is set to “N”, the value entered in the “Radio Address”
parameter is used. (Refer to “Radio Address” in this section for details about
manually assigned radio addresses.)
Important: Ensure that all terminals grouped in the system use the same
addressing process – that is, if you choose to use automatic
radio addressing, use this addressing process for all terminals
operating in the same system. If you choose to assign radio
addresses manually using the “Radio Address” parameter, use
this process for all terminals in the same system.
Radio Address
The value entered in the “Radio address” parameter is used to identify the
terminal over the radio link. A unique value from 1 to 3840 must be assigned
for each terminal.
Auto Radio Addr Y Y/N
Radio Address 0 1-3840
Initial RTT 0 0-1000
Range
802.IQ v1
To Next Page
Loading...