Appendix D: Radio Parameters
Channel
D-20
Teklogix 7035, 8255 & 8260 Terminals User Manual
Channel Enable
These parameters are used to enable (Y) or disable (N) up to 7 channels – the
maximum number of channels supported by the 902 spread spectrum radio.
Enabling a channel allows the channel to be set to an operating channel
(“Channel #”) and also makes the channel available for channel searching.
If, for example, the operating channel is 1 and all other channels are enabled,
the terminal may roam through all 7 channels. Note that the “Channel Enable”
menu only displays channels that have been configured with frequencies.
Channel Auto
These parameters are available in the “Chan-auto” sub-menu. “Next ch-auto”
determines the order of the auto-switched channels. In the first “Next ch-auto”
parameter, enter the number of the first channel to which you want the terminal
to consider switching. In the next parameter, enter the next channel, and so on.
Enter “0” (zero) for no channel.
CH 1 enable Y Y/N
•
•
•
CH 7 enable Y Y/N
Range
Chan enable
Next ch-auto 1 0-7
•
•
•
Next ch-auto 7 0-7
Range
Chan Auto
To Next Page