Chapter 7: Setting Parameters
Exiting Tekterm And Accessing The Display Menu
112
Teklogix 7035, 8255 & 8260 Terminals User Manual
Launching The Display Menu
To access any of these options, type the letter corresponding to the item you
want to access.
To launch the “Parameters” menu:
• Type the letter a.
A Password screen is displayed.
Note: A password is not requested when the terminal emulation application
is launched.
A Supervisory or a Psion Teklogix level password is required to access the complete
“Parameters” menu or the DOS prompt.
• Type your supervisory level password. The default Sup. Password is
123456.
• Press <ENTER>.
Important: To protect against accidental changes to the terminal parameter
settings and to limit user access, it is critical that you change this
default supervisory level password immediately. Refer to
“Security” on page 194 for details about personalizing
your password.
. . . . . .
Password
To Next Page
Loading...