Chapter 7: Setting Parameters
Screen
152
Teklogix 7035, 8255 & 8260 Terminals User Manual
Columns
This parameter defines the logical page width (in characters) used by the host
computer application. Emulator systems trim the host application screens to this
width. This page width cannot be smaller than the width of the terminal display.
Display panning is used if the page is wider than the display.
Rows
This parameter defines the logical page length (in lines) used by the host computer
application. Emulator systems trim the host application screens to this length. This
page length cannot be smaller than the length of the terminal’s display. Display
panning is used if the page is longer than the display.
Note: The value in this parameter must be an even number.
Auto Wrap
If “Auto Wrap” is disabled (set to “N”), characters received when the cursor is at the
right edge of the screen replace the previously displayed characters. If “Auto Wrap”
is enabled (set to “Y”), the cursor wraps to the next line when the current line is
filled. The display scrolls up if the cursor is at the bottom margin.
Disp Ctrls
This parameter is used to debug information from the ANSI host. Instead of acting
on the ANSI C0 and C1 controls, a character description of them is displayed on the
terminal screen.
Font Size
This parameter is used to change the font size displayed within the ANSI application
on 7035 hand-helds and 8255 and 8260 vehicle-mounts. Font sizes are represented
in lines x characters (rows x columns). Font availability varies depending on the
type of terminal used and the font package installed in the terminal.
• Press the <RIGHT> arrow key to scroll through the options.
Cursor Type
This parameter allows you to choose how you want the terminal cursor displayed.
You can choose either an Underline or Block cursor.
• Press the <RIGHT> arrow key to scroll through and choose an option.
To Next Page
Loading...