Teklogix 7035, 8255 & 8260 Terminals User Manual xxi
Approvals And Safety Summary
This safety information is for the protection of both operating and service personnel.
This equipment complies with Class A, Part 15 of the FCC rules. Operation is
subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
For sites in Canada, Teklogix TRX7431 and TRX7441 802.11b radios require a
radio licence unless they are installed totally within a building (user shall obtain
licence from Industry Canada).
Use only Teklogix approved peripheral devices and cables.
RF EXPOSURE REQUIREMENTS
For vehicle-mount terminals only – To satisfy FCC RF exposure require-
ments for mobile transmitting devices, a separation distance of 20 cm or
more should be maintained between the antenna of this device and persons
during device operation. To ensure compliance, operation at closer than this
distance is not recommended.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Operating Teklogix equipment where explosive gas is present may result in
an explosion.
DO NOT REMOVE COVERS OR OPEN ENCLOSURES
To avoid injury, the equipment covers and enclosures should only be
removed by qualified service personnel. Do not operate the equipment
without the covers and enclosures properly installed.
DO NOT HOLD ANTENNA
To avoid discomfort due to the local heating effect of Radio Frequency
energy, do not touch the antenna when a terminal is transmitting.
To Next Page
Loading...