Chapter 9: Specifications
Radio Specifications
226
Teklogix 7035, 8255 & 8260 Terminals User Manual
USA – Federal Communications Commission (FCC)
This equipment generates and may radiate radio-frequency energy. If it is not installed in accordance with
Cisco installation instruction, it may cause interference with radio and television reception. This equipment
has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of FCC
rules. These specifications are designed to provide reasonable protection against such interference in a
residential installation. However there is no guarantee that interference will not occur in a particular
installation.
You can determine whether your equipment is causing interference by turning it off. If the interference stops,
it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment causes
interference to radio or television reception, try to correct the interference by using one or more of the
following measures:
• Turn the television or radio antenna until the interference stops.
• Move the equipment to one side or the other of the television or radio.
• Move the equipment farther away from the television or radio.
Modification to this product not authorized by Cisco could void the FCC approval and negate your authority to
operate the product.
TRX7410 & TRX7410A TekLan 902 MHz Direct Sequence Spread Spectrum
(For Vehicle-Mount Terminals Only)
Transmit Power TRX7410=1 Watt, TRX7410A=250 mW
Frequency Range 902-928 MHz
Channels 7
Data Rates 121 kbps
*TRX7431 (WaveLAN/IEEE) PC Card IEEE 802.11 Direct Sequence
Spread Spectrum
Transmit Power 32 mW
Frequency Range 2.4 GHz - 2.5 GHz
Channels 11 (FCC)
13 (ETSI)
4 (FR)
1 (JP)
2 (SP)
Data Rates 1, 2, 5.5, 11 Mbps
* Refer to “Regulatory Information – TRX7431 WaveLAN/IEEE PC Card 802.11 DS SS” on
page 227 for installation and usage information.
To Next Page