Teklogix 7035, 8255 & 8260 Terminals User Manual D-11
Appendix D: Radio Parameters
TRX7441 802.11b DS SS Radio Parameters
The table following outlines the interaction between the “Auth Type” parameter and
“Mixed Cell” parameter settings.
WEP Encrypt (Wired-Equivalent Privacy)
This parameter encrypts radio traffic to protect it from electronic eavesdroppers. To
enable the encryption keys:
• Set the ‘WEP Encrypt’ parameter to ‘Y’.
The “WEP Encrypt” sub-menu provides four encryption keys – Key 1 to Key 4. The
transmit key – TX Key 1 – is used to define which encryption key will be used to
encrypt transmissions.
Authentication
Type
Mixed Cell = Y Mixed Cell = N
Open The terminal radio can operate in a
cell regardless of encryption used.
The Cisco Access point “Encryption
by Station” parameter must be set to
Open, “Authentication Accept Type”
parameter set to Open.
The terminal radio uses full encryption.
The Cisco Access point “Encryption by
Station” parameter must be set to
Full Encryption and “Accept
Authentication Type” parameter set to
Open.
The Psion Teklogix 9150 with “WEP
Enabled” uses this method.
Shared The terminal radio can operate over a
range of cells regardless of encryp-
tion used.
The Cisco Access point “Encryption
by Station” parameter must be set to
Optional, and “Accept Authenti-
cation Type” parameter must be set to
Shared.
The terminal radio uses full encryption.
The Cisco Access point “Encryption by
Station” parameter must be set to
Full Encryption and “Accept
Authentication Type” parameter set to
Shared.
None No authentication. No authentication.
Key 1 12345
Key 2
Key 3
Key 4
Tx Key 1
WEP Encrypt
To Next Page