ABL800 FLEX Operator's Manual 4. Sample measurements
Patient identification, Continued
Selecting a
report layout
To select a report layout, do the following:
Step Action
Highlight "Report Layout" with the up/down arrows on the Patient
Identification screen.
1.
2.
If "Report Layout" is included in the Patient ID, select a layout from
the list displayed on the right side of the screen, using the up/down
arrows. (The list of report layouts has been made in the Patient Report
Setup - see chapter 3: Installation and setup in this manual.)
If "Report Layout" is not included in the Patient ID, the text box is
separated from the rest of the items on the Patient Identification
screen.
You can select another report layout by highlighting the line on the
screen and selecting the desired layout. The patient report will be
saved in this layout.
NOTICE: If you are using mandatory input fields you are not allowed
to change the report layout during measurement unless the mandatory
fields have been filled.
It is possible to see updatings of the pH, pCO
2
, pO
2
, cK
+
, cNa
+
, cCa
2+
, cCl
–
, cGlu,
cLac and cCrea electrodes (the number of electrodes depends on the type of your
analyzer) during a measurement.
Electrode
updatings
To display the Electrode Updatings screen, press the Electrode Upd. button on the
Patient Identification screen.
Press Back to return to the on the Patient Identification screen.
Continued on next page
4-19
To Next Page
Loading...
Need help?
General
