RADIOMETER ABL800 FLEX - Page 81

ABL800 FLEX Operator's Manual 3. Installation and setup
Analysis setup, Continued
Selecting
parameter
profile
To select parameter profile for each measuring program, do the following:
Step Action
1.
Select a measuring program and press Parameters on the Syringe
Modes Setup or Capillary Modes Setup screen.
2.
Select parameters for a given measuring mode by pressing a parameter
check button (see Screen elements in chapter 2).
The list of available parameters depends on your analyzer version.
3.
Select the dynamic parameters option in the "Use dynamic
parameters" box as follows:
Parameters can be
selected before a
measurement.
Parameters can be
selected after a
measurement.
4.
Press the Back button to return to the Syringe Modes Setup or
Capillary Modes Setup screen.
A parameter is disabled, i.e. excluded from the Parameter Profile screen and the
parameter bar, in General Setup − Parameters and Input – Parameters.
Disabled versus
deselected
parameter
A parameter deselected
for the given syringe or capillary measuring program will
be measured, but excluded from the displayed and printed patient report.
You can further select or deselect a parameter before or after a measurement − see
chapter 4: Sample measurements.
Continued on next page
3-15