Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
14.6.1 DISPLAYING PROGRAMMING HELP
Any time you need to see a list of all the programming commands, use the “H” command.
9785-P>H [ENTER]
When you invoke the “H” command, the programming menu shown in Figure 14-5 will re-appear on
your screen.
14.6.2 LEAVING THE PROGRAMMING MODE
NOTE
Before leaving the Programming Mode, if you don’t use the “SV”
command your changes will be lost.
Whenever you are finished programming the RFL 9785, use the “Q” command:
9785-P>Q [ENTER]
The “Q” command tells the RFL 9785 to leave the programming mode and return to the normal
“9785>” prompt. If you changed any setting while in the programming mode, be sure to use the “SV”
command described above to save the changes before invoking the “Q” command; otherwise, your
changes will be lost.
14.6.3 SAVING NEW PROGRAMMING SETTINGS
The “SV” command saves any new settings you made while in the programming mode:
9785-P>SV [ENTER]
The “SV” command tells the RFL 9785 to store all the changes in its non-volatile memory. Once the
changes are stored, the “9785-P>” prompt will re-appear.
Before you enter the “SV” command, the RFL 9785 operates according to the old parameter settings.
Once the “SV” command is entered, the new settings will be in effect.
The new parameter settings can be verified by re-issuing the “D” command to display the parameter
settings list. (For more information on the “D” command, go to paragraph 14.6.4.)
RFL 9785 RFL Electronics Inc.
April 25, 2005
14-7 (973) 334-3100
To Next Page
Loading...
