Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
H – Display programming help
Q – Leave programming menu
SV – Save new settings
C – Change password (superuser aut
horization required)
D – Display present settings and parameter numbers
## - Edit this specific number parameter
9785CB-P> _
Figure 16-15. Typical programming menu
Command Meaning Paragraph
H Display programming help 16.6.3
Q Leave programming menu 16.6.3.4
SV Save new setting 16.6.3.3
C Change password 16.6.3.1
D Display current settings and parameter numbers 16.6.3.2
16.6.3.1 CHANGING THE PROGRAMMING PASSWORD
You can use the “C” command to change the password that can be used to enter the programming
mode.
Format: 9785CB-P>C [ENTER]
When you enter the “C” command, the Checkback Module sends the following prompt to your
terminal:
enter super-user:
Enter the super-user password (“BCCE”), and then press [ENTER]. The following prompt will appear:
Current password is (current password)
enter new password:
Enter the new password, and then press [ENTER]. The following prompt will appear:
repeat new password:
Enter the new password again, and then press [ENTER]. The following prompt will appear:
password modified
The new password is now stored in the Checkback Module’s non-volatile RAM memory.
RFL 9785 RFL Electronics Inc.
July 26, 2007 16-20 (973) 334-3100
To Next Page
Loading...
