Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
RFL 9785 RFL Electronics Inc.
July 26, 2007 16-17 (973) 334-3100
The values display shows the code number for each measured value, a brief description of its meaning,
and its value. Full descriptions for each measured value are as follows:
004 - Block Received
The current status of the BLOCK output.
005 - ChkBk Output
The current status of the Checkback output.
006 - Tests Since Rst
The number of checkback tests run since the last time the test log was reset. This total includes
automatic and manually-initiated tests.
007 - Tests Passed
The number of successful checkback tests since the last time the test log was reset. This total
includes automatic and manually-initiated tests.
008 - Tests Failed
The number of unsuccessful checkback tests since the last time the test log was reset. This total
includes automatic and manually-initiated tests.
009 - Last Failed
The number of the last code that should have been received, but failed.
010 - Last Rx Code
The number of the last valid code received.
011 - Hours To Next
The number of hours until the next automatic checkback tests is initiated
16.6.2.4 VIEWING THE PARAMETER SETTINGS DISPLAY
The “D” command tells the Checkback Module to send a list of all parameter settings to your terminal.
This list of settings is called the “read settings” menu.
Format: 9785CB>D [ENTER]
A typical read settings menu appears in Figure 16-12. All the currently-active parameter settings but
you can’t change the displayed values. To change these values, you will have to enter the
programming mode. See paragraph 16.6.3 for more information. The programming mode is password-
protected, so only authorized persons can change the Checkback Module’s parameter settings.
To Next Page
Loading...
