Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
RFL 9785 RFL Electronics Inc.
July 26, 2007 16-29 (973) 334-3100
16.6.4.3 LEAVING THE TEST MODE
Whenever you are finished running checkback tests, use the “Q” command:
Format: 9785CB-T>Q [ENTER]
The “Q” command tells the Checkback Module to leave the test mode. The list of APRIL commands in
Figure 16-9 will reappear, with the normal “9785CB>” prompt beneath it.
16.6.4.4 RETURNING TO NORMAL CHECKBACK MODULE OPERATION
Once you are finished accessing the Checkback Module using APRIL, make sure you have returned to
the “9785CB>” prompt:
1. If you were in the Test Mode, press the [Q] and [ENTER] keys to return to the “9785CB>”
prompt.
2. If you were in the Update Mode, press the [X] and [ENTER] keys to return to the “9785CB>”
prompt.
When the “9785CB>” prompt is displayed, simply disconnect your PC or terminal from the Checkback
Module’s RS-232 connector. If you accessed the Checkback Module through an RFL 9660 Digital
Switch, type in the deselect code (normally “BYE”) to deselect the port, and then enter the “Q”
command to terminate the session. (Refer to the RFL 9660 Instruction Manual for more information.)
To Next Page
Loading...
