RFL 9785 - Page 61

Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
4.7.5 FORCE LOCAL BLOCK
The system can be configured to automatically enable the Block output when it is transmitting a block
to the remote end. This can be enabled or disabled using switch SW2-1 on the AM Logic module. See
paragraph 6.3.3 for more information. It should also be noted that the same function is often
accomplished by connecting the Tx and Rx ports of the unit by installing a jumper on the line I/O
module.
4.7.6 RX VOICE LEVEL
The system can be configured for high or low voice levels using switch SW2-2 on the AM Logic
module. Systems are normally configured for high voice level. See paragraph 6.3.7 for more
information.
RFL 9785 RFL Electronics Inc.
March 24, 2008 4-11 (973) 334-3100