Ricoh D117 - Pcdu (Cmy)

Image Creation
D117/D118 4-48 SM
4.7.2 PCDU (CMY)
The removal procedure of the PCDU (CMY) is same as for PCDU (K). However, it is not
necessary to release the lock lever.
1: Tension released
2: Tension applied
 Check that the ITB has no tension before PCDU (CMY) replacement. Otherwise, the ITB
may be damaged.
 The tension of the ITB can be released as follows.
 Turn the pressure release screw [A] to the left, until the flat part of the half moon on the
screw points to the right [1].