Ricoh D117 - Page 413

SC Tables
D117/D118 6-52 SM
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
835
CTL
B
Self-diagnostic error: Standard SDRAM DIMM
[XXXX]: Detailed error code
[1102]
Loopback connector is connected but check results in an error.
 IEEE1284 connector error
 Centronic loopback connector defective
1. Replace the controller board.
[110C]
Loopback connector is connected but check results in an error.
 ASIC device error
 IEEE1284 connector error
 Centronic loopback connector defective
1. Replace the controller board.
[1120]
Centronic loopback connector is not connected for detailed
self-diagnostic test.
 Centronic loopback connector not connected correctly
 Centronic loopback connector defective
 ASIC device defective
1. Replace the controller board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
838
CTL
D
Self-diagnostic Error: Clock Generator
[XXXX]: Detailed error code
[2701]
A verify error occurred when setting data was read from the clock
generator via the I2C bus.
 Defective clock generator
 Defective I2C bus
 Defective I2C port on the CPU
1. Replace the controller board.