GX-6000 Operator’s Manual About this Manual • 6
About this Manual
Although the GX-6000 can support up to 6 sensors, this manual specifically
describes an instrument with the four standard sensors and a PID sensor. See
the appendices for descriptions of other sensors.
The GX-6000 Operator’s Manual uses the following conventions for notes,
cautions, and warnings.
NOTE: Describes additional or critical information.
CAUTION: Describes potential damage to equipment.
WARNING: Describes potential danger that can result in injury or death.
The GX-6000 Operator’s Manual is organized as follows:
• Chapter 1 is an introduction to the GX-6000.
• Chapter 2 describes the components of the GX-6000.
• Chapter 3 describes the operation of the GX-6000.
• Chapter 4 describes Calibration Mode which allows you to calibrate the
GX-6000’s active channels.
• Chapter 5 describes the GX-6000’s User Mode.
• Chapter 6 describes the GX-6000’s maintenance requirements and
procedures.
• Appendix A describes Maintenance Mode which allows you to configure
different parameters of the GX-6000.
• Appendix B describes Maintenance Mode 2 which allows you to change
the GAS COMB and HC SELECT parameters.
• Appendix C describes the ESS-03 sensors and the operation of the GX-
6000 with an ESS-03 sensor installed.
• Appendix D describes the IR sensors and the operation of the GX-6000
with an IR sensor installed.
• Appendix E describes the operation of the GX-6000 in Leak Check
Mode.
• Appendix F describes the operation of the GX-6000 in Bar Hole Mode.
• Appendix G describes the operation of the GX-6000 in Inert Mode.
• Appendix H describes the 10.0 eV/benzene PID sensor.
To Next Page
Loading...
