57 • Display Mode GX-6000 Operator’s Manual
Select Station ID Screen
This screen only appears in Display Mode if the ID DISPLAY item in
Maintenance Mode is set to ON. Use this screen to select a station ID from
the station ID list in the GX-6000’s memory. The current station ID is
displayed. A station ID can be up to 16 characters long. The GX-6000 can
store up to 128 station IDs.
The station ID provides a way to identify a location where monitoring was
done during a data logging session. If the station ID is changed during an
operating session, a new data session is initiated with the new station ID
attached to it. This allows you to change the station ID during operation and
have each station ID that was used during an operating session saved for the
corresponding data. See the GX-6000 Data Logger Management Program
Operator’s Manual for a detailed description of data logging and the station
ID.
The station ID list cannot be edited using the GX-6000 user interface. The
GX-6000 Maintenance Data Loader Program is required to define or change
station IDs in the station ID list. For a detailed description of editing the list
of station IDs stored in the GX-6000, see the GX-6000 Maintenance Data
Loader Program Operator’s Manual.
To Next Page
Loading...
Need help?
General
