GX-6000 Operator’s Manual Using Maintenance Mode • 172
3 . Use ▲AIR or SHIFT ▼ (PANIC) to display the desired setting.
4 . If you selected OFF, press and release POWER/ENTER to save the
setting and return to the main menu.
If you selected ON, continue with Step 5.
5 . Press and release POWER/ENTER. The Set Password Screen appears.
0000 is at the bottom of the screen with the first 0 flashing.
6 . Use ▲AIR or SHIFT ▼ (PANIC) to display a number from 0 to 9.
7 . Press and release POWER/ENTER to enter the selection and advance to
the next number.
8 . Repeat Step 6 and Step 7 to select the remaining numbers. When you
press and release POWER/ENTER to enter the last number, the
password is saved and you return to the main menu.
Restoring the Default Settings
Each of the GX-6000 setup parameters, such as the auto calibration values,
zero and span settings, or parameters in Maintenance Mode, has a default
setting. For the items in Maintenance Mode, the default settings are the same
as the standard factory settings. If you want to return the GX-6000 to its
default configuration, it is possible to do so by using the Default Settings
menu item in Maintenance Mode. Returning the GX-6000 to its default
configuration can be useful if various setup parameters have been changed in
the field and you want to return the GX-6000 to its original configuration as
shipped from the factory.
There are some special GX-6000 configurations that may have a different
default configuration than the standard. Consult RKI Instruments, Inc. for
information regarding non-standard default configurations.
MAINTE
MAINTE PASSWORD
INPUT
PASSWORD
0 0 0 0
To Next Page
Loading...
