GX-6000 Operator’s Manual Using Maintenance Mode • 164
Turning the Key Tone Noise On or Off
With KEY TONE set to ON (factory setting), the instrument will beep every
time a button is pressed.
With KEY TONE set to OFF, the instrument will not beep when a button is
pressed.
1 . From the main menu, place the cursor next to KEY TONE.
2 . Press and release POWER/ENTER. The Key Tone Screen appears.
3 . Use ▲AIR or SHIFT ▼ (PANIC) to display the desired setting.
4 . Press and release POWER/ENTER to save the setting and return to the
main menu.
Turning Inert Mode On or Off
With INERT MODE set to ON, Inert Mode becomes an option in the Mode
Select Screen when the instrument turns on. Normal Mode is still an option.
See “Appendix G: Using the GX-6000 in Inert Mode” on page 223 for a
description of Inert Mode.
With INERT MODE set to OFF (factory setting), selecting Inert Mode at
startup is not an option.
1 . From the main menu, place the cursor next to INERT MODE.
2 . Press and release POWER/ENTER. The Inert Mode Screen appears.
3 . Use ▲AIR or SHIFT ▼ (PANIC) to display the desired setting.
4 . Press and release POWER/ENTER to save the setting and return to the
main menu.
Updating the Leak Check/Bar Hole Mode Setting
With L./B. MODE set to LEAK CHECK MODE/BAR HOLE MODE, the
Mode Select Screen appears when the unit is turned on. You are able to select
from Normal Mode, Leak Check Mode, and Bar Hole Mode.
With L./B. MODE set to BAR HOLE MODE, the Mode Select Screen
appears when the unit is turned on. You are able to select from Normal Mode
and Bar Hole Mode.
With L./B. MODE set to LEAK CHECK MODE, the Mode Select Screen
appears when the unit is turned on. You are able to select from Normal Mode
and Leak Check Mode.
With L./B. MODE set to OFF, the Mode Select Screen does not appear when
the unit is turned on and the unit goes into Normal Mode after the start up
sequence.
To Next Page
Loading...
Need help?
General
