13 • Included Accessories GX-6000 Operator’s Manual
Included Accessories
Included accessories consist of the tapered rubber nozzle, belt clip, rubber
boot, wrist strap, and the sample hose/probe.
Tapered Rubber Nozzle
A cone shaped 4 inch long rubber nozzle is included with the GX-6000 as
standard. It can be installed on the inlet fitting by pushing the larger end over
it. The smaller end can be inserted through a hole in a wall or some other
access to an enclosed area to sample the environment.
Belt Clip
A belt clip can be mounted to the back of the case using 3 phillips head
screws. The belt clip allows the GX-6000 to be securely attached to a belt.
Rubber Boot
A protective rubber boot can be installed over the GX-6000.
Wrist Strap
A wrist strap is included with the GX-6000 and can be attached to the right or
left wrist strap installation feature on the GX-6000 case.
Sample Hose and Probe
A 3 foot sample hose with an attached probe is standard with the GX-6000.
When desired, the rubber nozzle may be removed and the sample hose and
probe may be connected to the inlet fitting. Sample hose lengths are available
from 3 feet to 50 feet (see “General Parts List” on page 137). The quick
connect end of the sample hose connects to the inlet fitting of the GX-6000.
The probe is integral with the hose and connects to it with a tube fitting.
CAUTION: Sample hose lengths of more than 50 feet are not recommended
for the GX-6000 because of flow rate reduction.
The probe includes a replaceable particle filter and hydrophobic filter disk
that prevent particulates and water from entering the GX-6000’s flow system.
See “Replacing the Probe’s Particle Filter and Hydrophobic Filter Disk” on
page 115 for instructions to replace the particle filter and hydrophobic filter
disk.
To Next Page
Loading...
Need help?
General
