Roche Diagnostics
Instructions for Use · Version 13.0 157
cobas b 123 POC system 6 Measurement
Configuring the parameter selection field
Configuring the parameter selection field
The parameter selection field in the Overview tab makes it easier to view which
parameters are available before performing a measurement.
You can permanently disable parameters for measurements and calibrations, so these
parameters do not appear in the parameter selection field. In addition, you can
temporarily disable parameters for a measurement.
p To permanently enable and disable parameters for measurements and
calibrations
1
Utilities > Configuration > Measurement > Parameter > Activ./deactiv.
Figure 6-5 Permanently activating and deactivating parameters screen
2
To enable or disable a parameter for measurements, press on the parameter’s
button.
Parameters, which are shown in dark green, are permanently enabled for
measurements.
Parameters, which are shown in light green, are permanently disabled for
measurements.
3
To enable or disable a parameter for calibrations, press on the parameter’s
ON/OFF button.
Parameters, which have an ON button, are permanently enabled for calibrations.
Parameters, which have an OFF button, are permanently disabled for
calibrations.
s
p To temporarily enable and disable parameter for measurements
q
If you disable a parameter on the Overview tab for a measurement, it is automatically
available for the next measurement.
1
In the Overview tab, select the parameters that you want to measure.
Parameters colored in dark green will be measured.
Parameters colored in light green will not be measured.