Rockwell Automation Allen-Bradley 2094-BM01-S - Configure the Logix SERCOS interface Module

Rockwell Automation Publication 2094-UM001D-EN-P - May 2010 133
Configure and Start Up the Kinetix 6000 Drive System Chapter 6
Configure the Logix
SERCOS interface Module
This procedure assumes that you have wired your Kinetix 6000 system and have
configured the communication rate and optical power switches.
For help using RSLogix 5000 software as it applies to configuring the
ControlLogix, CompactLogix, or SoftLogix SERCOS modules, refer to
Additional Resources on page 12
.
Configure the Logix Controller
Follow these steps to configure the Logix controller.
1. Apply power to your Logix chassis containing the SERCOS interface
module/PCI card and open your RSLogix 5000 software.
2. From the File menu, choose New.
The New Controller dialog box opens.
3. Configure the new controller.
a. From the Type pull-down menu, choose the controller type.
b. From the Revision pull-down menu, choose the revision.
c. Type the file Name.
d. From the Chassis Type pull-down menu, choose the chassis.
e. Enter the Logix processor slot.
4. Click OK.
5. From the Edit menu, choose Controller Properties.