Rockwell Automation Allen-Bradley 2094-BM01-S - Reconnect SERCOS Communication

252 Rockwell Automation Publication 2094-UM001D-EN-P - May 2010
Appendix D DC Common Bus Applications
The save to non-volatile memory is complete and this confirmation
message dialog box opens.
4. Click OK.
5. Close the DriveExplorer software.
Reconnect SERCOS Communication
Follow these steps to reconnect SERCOS communication.
1. Remove three-phase and control power from the Kinetix 6000 drive
system.
2. Replace the SERCOS fiber-optic cable removed earlier.
Fiber-optic cable connections (Tx and Rx) are located on the top of each
IAM/AM module.
3. Re-apply three-phase and control power.