Rockwell Automation Allen-Bradley 2094-BM01-S - Wiring the Feedback and I;O Connectors; Connect Premolded Motor Feedback Cables

Rockwell Automation Publication 2094-UM001D-EN-P - May 2010 115
Connecting the Kinetix 6000 Drive System Chapter 5
Wiring the Feedback and
I/O Connectors
These procedures assume you have mounted your Kinetix 6000 system,
completed all power wiring, and are ready to connect your feedback and I/O
cables.
Connect Premolded Motor Feedback Cables
Motor feedback cables with premolded connectors plug directly into 15-pin
motor feedback (MF) connectors on either the IAM or AM modules (no wiring
is necessary).
Figure 60 - IAM/AM Module (MF connector)
For This Connection Go to
Premolded cable Connect Premolded Motor Feedback Cables on page 115.
Panel-mounted breakout board Connect Panel-mounted Breakout Board Kits on page 116.
Low-profile connector Wire Low-profile Connector Kits on page 117
.
IMPORTANT
When using Bulletin 2090 cables with premolded connectors, tighten the
mounting screws (finger tight) to improve system performance.
Kinetix 6000, Front View
(IAM module is shown)
Kinetix 6000, Side View
(IAM module is shown)
Premolded Connector
(2090-UXNFBMP-Sxx Cable
Motor Feedback (MF) Connector