Rockwell Automation Publication 2094-UM001D-EN-P - May 2010 173
Chapter
8
Removing and Replacing the Kinetix 6000
Drive Modules
Introduction
This chapter provides remove and replace procedures for your Kinetix 6000
system components.
Before You Begin
You will need these tools available before you begin removal and replacement
procedures:
• A screwdriver
• A small screwdriver, 3.5 mm (0.14 in.)
• Vo l tm e t er
Topic Page
Introduction 173
Before You Begin 173
Remove Kinetix 6000 Drive Modules 174
Replace Kinetix 6000 Drive Modules 175
Remove the Power Rail 176
Replace the Power Rail 177
ATTENTION: This drive contains electrostatic discharge (ESD) sensitive
parts and assemblies. You are required to follow static-control
precautions when you install, test, service, or repair this assembly. If you
do not follow ESD control procedures, components can be damaged. If
you are not familiar with static control procedures, refer to Guarding
Against Electrostatic Damage, publication 8000-4.5.2
, or any other
applicable ESD awareness handbook.
To Next Page
Loading...
