Rockwell Automation Allen-Bradley 2094-BM01-S - Configure the Logix Module

Rockwell Automation Publication 2094-UM001D-EN-P - May 2010 135
Configure and Start Up the Kinetix 6000 Drive System Chapter 6
Configure the Logix Module
Follow these steps to configure the Logix module.
1. Right-click I/O Configuration in the Controller Organizer and choose
New Module.
The Select Module dialog box opens.
2. Expand the Motion category and select 1756-MxxSE, 1756-L60M03SE,
1768-M04SE, or 1784-PM16SE as appropriate for your actual hardware
configuration.
In this example, the 1756-M16SE module is selected.
3. Click OK.
The New Module dialog box opens.
4. Configure the new module.
a. Type the module Name.
b. Enter the Logix SERCOS module slot (leftmost slot = 0).
c. Check Open Module Properties.
5. Click OK.