240 Rockwell Automation Publication 2094-UM001D-EN-P - May 2010
Appendix C Upgrading the Kinetix 6000 Drive Firmware
The Axis to Flash dialog box opens.
9. Click (check) each axis to flash.
Example above shows two axes to flash checked.
10. Click OK.
The Axes to Flash parameter is set.
11. Close DriveExplorer software.
HyperTerminal Configuration
Follow these steps to begin a new HyperTerminal session.
1. From the Windows Start menu, choose Programs\Accessories\
HyperTerminal\HyperTerminal.
The New Connection dialog box opens.
2. Type a name the new HyperTerminal file and choose an icon for the
connection.
3. Click OK.
To Next Page
Loading...
