244 Rockwell Automation Publication 2094-UM001D-EN-P - May 2010
Appendix C Upgrading the Kinetix 6000 Drive Firmware
The flash upgrade operation begins and this dialog box opens.
The flash operation completes and this dialog box opens.
9. Close the HyperTerminal session.
10. Verify that parameter 30 for each axis module is now upgraded to the new
firmware revision.
Return to DriveExplorer software (refer to Select Axis Modules to Upgrade,
page 239
) to see the linear list of parameters.
ATTENTION: To avoid unrecoverable fault to drive modules, do
not interrupt control power to IAM module, power to the
1203-SSS SCANport adapter, or power to your personal computer
while the flash upgrade operation is in progress.
To Next Page
Loading...
