Rohde & Schwarz ESW Series - Page 638

Remote Commands in the Receiver Application
R&S
®
ESW
638User Manual 1177.6298.02 ─ 08
[SENSe:]CORRection:TRANsducer:UNIT <Unit>
This command selects the unit of the transducer factor.
Before you can use the command, you have to select and turn on a transducer.
Parameters:
<Unit> string as defined in table below
*RST: DB
Example:
CORR:TRAN:UNIT 'DBUV'
String Unit
'DB' dB
'DBM' dBm
'DBMV' dBmV
'DBUV' dBμV
'DBUV/M' dBμV/m
'DBUA' dBμA
'DBUA/M' dBμA/m
'DBPW' dBpW
'DBPT' dBpT
[SENSe:]CORRection:TSET:BREak <State>
This command turns a transducer break on and off.
Before you can use the command, you have to select a transducer set with [SENSe:
]CORRection:TSET:SELect.
Parameters:
<State> ON | OFF
*RST: OFF
Example: See Chapter 15.9.4, "Transducers", on page 629 .
[SENSe:]CORRection:TSET:CATalog?
This command queries all transducer sets stored on the R&S ESW.
Return values:
<UsedDiskSpace> Size of all available files containing transducer factors in byte.
<FreeDiskSpace> Remaining disk space in bytes.
<FileInfo> String containing the file information.
'<NameFileN>,<SizeFileN>'
<NameFileN>
Name of the file.
General Instrument Setup