File and Data Management
R&S
®
SMA100B
303User Manual 1178.3834.02 ─ 05
frequently the same network drive. In these cases, on a R&S SMA100B connected to a
LAN you can create a shortcut to this network folder or this computer.
For information on how to set up a LAN connection, refer to:
●
Chapter 2.1.3, "Setting Up a Network (LAN) Connection", on page 28
●
Chapter 12, "Network Operation and Remote Control", on page 346
To map a network folder, proceed as follows:
1. On the computer or the network folder you want to map, enable remote access.
You can specify a list of users allowed for remote access.
The remote access settings depend on the operating system the remote computer
is using. For step-by-step instructions, refer to the documentation of the particular
operating system.
2. On the R&S SMA100B, enable file transfer via SMB (samba).
3. Select "System Config > Setup > Remote Access > Network".
Select:
a) "Address Mode > Auto (DHCP)"
b) Check that the "DNS Suffix" and "DNS Server" are correct.
4. In the "Save/Recall" dialog, select "File Manager > Map Network Share".
5. In the "Map Network Share" dialog, select:
a) In the "Network Folder" field, enter //<IP Address>/user or //
<Server Name>/user.
b) In the "Local Folder" field, enter an alias name, e.g. setups.
c) Enter the "User Name" and "Password" of a user with a remote access permis-
sion to the selected network folder.
d) If necessary, enable "Reconnect at Startup".
e) Select "Connect".
The selected network folder is mapped to your instrument. The list of mapped net-
work folders is updated.
Using the File Manager
To Next Page
Loading...
