Rohde & Schwarz SMAB-B92 - Page 528

Remote Control Commands
R&S
®
SMA100B
526User Manual 1178.3834.02 ─ 05
[:SOURce<hw>]:PM<ch>:STATe......................................................................................526
[:SOURce<hw>]:PM<ch>:SOURce.................................................................................. 526
[:SOURce<hw>]:PM:MODE............................................................................................ 527
[:SOURce<hw>]:PM:DEViation:MODE............................................................................. 527
[:SOURce<hw>]:PM:DEViation:SUM................................................................................527
[:SOURce<hw>]:PM:RATio..............................................................................................528
[:SOURce<hw>]:PM:SENSitivity?.................................................................................... 528
[:SOURce]:PM<ch>[:DEViation].......................................................................................528
[:SOURce<hw>]:PM<ch>:STATe <State>
Activates phase modulation.
Activation of phase modulation deactivates frequency modulation.
Suffix:
PM<ch>
.
1|2
Sets the modulation signal channel.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Performing phase modulation" on page 524.
Manual operation: See "State" on page 79
[:SOURce<hw>]:PM<ch>:SOURce <Source>
Selects the modulation source for phase modulation signal.
Suffix:
PM<ch>
.
1|2
Sets the modulation signal channel.
Parameters:
<Source> LF1 | LF2 | NOISe | EXT1 | EXT2 | INTernal | EXTernal
LF1|LF2
Uses an internally generated LF signal.
EXT1|EXT2
Uses an externally supplied LF signal.
NOISe
Uses the internally generated noise signal.
INTernal
Uses the internally generated signal of LF1.
EXTernal
Uses an external LF signal (EXT1).
*RST:
LF1 <PM1>; LF2 <PM2>
Example: See Example "Performing phase modulation" on page 524.
Manual operation: See "Source" on page 79
SOURce Subsystem