Remote Control Commands
R&S
®
SMA100B
557User Manual 1178.3834.02 ─ 05
[:SOURce<hw>]:ILS[:GS|GSLope]:FREQuency:SYNChronize[:STATe] <Mode>
Activates synchronization of the ILS glide slope ICAO channel with the ILS localizer
ICAO channel.
The ILS glide slope/localizer frequency of the ICAO channel (Table 5-2) is set automat-
ically.
Parameters:
<Mode> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configure and generate an ILS glide slope signal"
on page 542.
[:SOURce<hw>]:ILS[:GS|GSLope]:ICAO:CHANnel
<Channel>
Sets the ICAO channel and the corresponding transmitting frequency.
If avionic standard modulation is activated and you change the "RF Frequency", the
frequency value of the closest ICAO channel is applied automatically. The "ICAO
Channel" is also updated.
The ICAO channel settings for ILS glide slope/localizer components are coupled. For
an overview of the ILS ICAO channel frequencies, see Table 5-2.
Parameters:
<Channel> CH18X | CH18Y | CH20X | CH20Y | CH22X | CH22Y | CH24X |
CH24Y | CH26X | CH26Y | CH28X | CH28Y | CH30X | CH30Y |
CH32X | CH32Y | CH34X | CH34Y | CH36X | CH36Y | CH38X |
CH38Y | CH40X | CH40Y | CH42X | CH42Y | CH44X | CH44Y |
CH46X | CH46Y | CH48X | CH48Y | CH50X | CH50Y | CH52X |
CH52Y | CH54X | CH54Y | CH56X | CH56Y
*RST: CH18X
Example: See Example "Configure and generate an ILS glide slope signal"
on page 542.
Manual operation: See "ICAO Channel" on page 129
[:SOURce<hw>]:ILS[:GS|GSLope]:LLOBe[:FREQuency] <Frequency>
Sets the modulation frequency of the antenna lobe arranged at the bottom viewed from
the air plane for the ILS glide slope modulation signal.
Parameters:
<Frequency> float
Range: 100 to 200
Increment: 0.05
*RST: 150
Example: See Example "Configure and generate an ILS glide slope signal"
on page 542.
SOURce Subsystem
To Next Page
Loading...
