Analog Modulations
R&S
®
SMA100B
86User Manual 1178.3834.02 ─ 05
Pulse Mode
Sets the operating mode of the pulse generator. Depending on the selection, the instru-
ment displays the associated parameters.
"Single"
Generates a single pulse in one pulse period.
"Double"
Generates two pulses in one pulse period.
"Train"
Option: R&S SMAB-K27
Generates a user-defined pulse train.
See Chapter 4.4.3.2, "Pulse Generator > Pulse Train Settings",
on page 89.
Remote command:
[:SOURce<hw>]:PULM:MODE on page 530
Trigger Mode
Selects between continuous triggering or triggering initiated by a trigger event from an
external signal.
See also "Input and output connectors" on page 74.
"Auto"
Generates the internal modulation signal continuously.
"Single"
The pulse generator is triggered by an internal trigger event, initiated
with Execute Single Trigger.
The pulse signal is generated once.
"Ext Single"
Generates a single pulse signal, triggered by an external signal.
Modulation Settings
To Next Page
Loading...
