Rohde & Schwarz SMAB-B92 - Page 532

Remote Control Commands
R&S
®
SMA100B
530User Manual 1178.3834.02 ─ 05
SOURce:PULM:STATe 1
OUTPut1:STATe 1
The following commands are available:
[:SOURce<hw>]:PULM:MODE........................................................................................ 530
[:SOURce<hw>]:PULM:TRIGger:MODE...........................................................................530
[:SOURce]:PULM[:INTernal][:TRAin]:TRIGger:IMMediate................................................... 531
[:SOURce<hw>]:PULM:PERiod....................................................................................... 531
[:SOURce<hw>]:PULM:WIDTh........................................................................................531
[:SOURce<hw>]:PULM:DELay........................................................................................ 531
[:SOURce<hw>]:PULM:DOUBle:DELay............................................................................532
[:SOURce<hw>]:PULM:DOUBle:WIDTh........................................................................... 532
[:SOURce<hw>]:PULM:DOUBle:STATe............................................................................ 532
[:SOURce<hw>]:PULM:STATe.........................................................................................532
[:SOURce<hw>]:PULM:SOURce..................................................................................... 533
[:SOURce<hw>]:PULM:TTYPe........................................................................................533
[:SOURce<hw>]:PULM:OUTPut:VIDeo:POLarity...............................................................533
[:SOURce<hw>]:PULM:POLarity..................................................................................... 534
[:SOURce<hw>]:PULM:IMPedance..................................................................................534
[:SOURce<hw>]:PULM:THReshold..................................................................................534
[:SOURce<hw>]:PULM:MODE <Mode>
Selects the mode for the pulse modulation.
Parameters:
<Mode> SINGle | DOUBle | PTRain
SINGle
Generates a single pulse.
DOUBle
Generates two pulses within one pulse period.
PTRain
Generates a user-defined pulse train.
Specify the pulse sequence with the commands:
[:SOURce<hw>]:PULM:TRAin:ONTime
[:SOURce<hw>]:PULM:TRAin:OFFTime
[:SOURce<hw>]:PULM:TRAin:REPetition
*RST:
SINGle
Example: See Example "Perform pulse modulation" on page 529.
Options: PTRain requires R&S SMAB-K27
Manual operation: See "Pulse Mode" on page 86
[:SOURce<hw>]:PULM:TRIGger:MODE <Mode>
Selects a trigger mode - auto, single, external, external single or external gated - for
generating the modulation signal.
SOURce Subsystem