DescriptionCommand
Turn an audio channel, or group,
on at the level it was last on at, or
leave it unchanged as the
channel is already on-air. This
can be useful if you want to take
an audio channel, or group, on-air
at once. You can use the Audio
Channel On for either the
program or preset buses.
Audio CH On
Adjust the audio gain for a group.
(Lawo Ember+ only.)
1. Use the Group knob to select
the audio group that you want
to adjust the gain for.
2. Use the Level knob to select
the new gain level you want
set for the group.
Audio Gain
Recall a memory that has been
stored on the Audio Mixer. This
can be used to take a number of
audio channels on-air at different
levels all at once. Refer to the
documentation that came with
your Audio Mixer for more
information on storing audio
memories.
Audio Memory
Un-mute an audio channel, or
group. This is the same as
pressing mute on the Audio
Mixer.
Audio Mute Off
Mute an audio channel, or group.
This is the same as pressing
mute on the Audio Mixer.
Audio Mute On
Turn PFL (pre-fade listen) on or
off for an audio channel group.
1. Use the Group knob to select
the audio group that you want
to turn PFL on or off for.
2. Use the PFL knob to turn
PFL on (ON) or off (OFF).
Audio PFL
DescriptionCommand
Override the levels for audio
channels on the preset bus. If the
audio channel is already on-air,
you can change the level or take
it off-air, if the channel is off, you
can take the channel on-air as an
override. PST Audio Level events
differ from Audio Channel On
events in that you select the level
that you want the audio channel
to be set to. When run, the event
will alter the level of the channel,
even if it is on-air. Audio CH On
will only take the channel on-air
if it is off and will not change the
level. This could be useful when
you want to alter the levels of a
number of channels, or groups,
at the same time.
Audio PST Lvl
Return to the normal audio follow
video mode and remove all
currently selected overrides. This
can be performed for either the
program or the preset bus. You
must set up two custom controls
if you want to perform both
independently.
Audio Reset
Recalls an audio memory
(snapshot) by name. Audio mixer
must support recalling memories
(snapshots) by name.
• Use the Snap Shot knob to
select the memory you want
to recall.
AudMemByName
86 • Custom Controls — Acuity Operation Manual (v9.2)
To Next Page
Loading...
Need help?
General
