Schweitzer Engineering Laboratories SEL-701 - Table 6.15 SHOW Command Options

701 Motor Protection Relay Date Code 20010719
ASCII Serial Port Operation
Command Explanations
6.24
SHOW (Level 1 or 2)
Use the SHOW command to view relay settings, serial port settings, and SER
settings. SHOW command options are listed in Table 6.15.
Table 6.15 SH OW Command Opt ions
You may append a setting name to each of the commands to specify the first
setting to display (e.g., SHO 50P1P displays the relay settings starting with setting
50P1P). The default is the first setting.
The SHOW commands display only the enabled settings. To display all
settings, including disabled/hidden settings, append an A to the SHOW command
(e.g., SHOW A).
Table 6.15 SHOW Command Options
Command Description
SHOW Show relay settings.
SHO P n Show serial port settings. n specifies the port (F or R);
n defaults to the active port if not listed.
SHO R Show SER settings.