Schweitzer Engineering Laboratories SEL-701 - Command Explanations; Figure 6.3 HELP Command Response

701 Motor Protection Relay Date Code 20010719
ASCII Serial Port Operation
Command Explanations
6.10
Command Explanations
Each command explanation lists:
 The command.
 The serial port access levels where the command is available, in
parentheses.
 An explanation of the command use or response.
For example, you can execute the HELP command, below, from serial port
Access Level 1 or 2.
HELP (Level 1 or 2)
Use the HELP command to display the available serial port commands. For more
details regarding a particular command, type HELP CMD, where CMD is the name of
the command you are interested in. Figure 6.3 shows an example HELP command
response.
=>HELP
Relay Serial Port Commands:
Command (Access Level) Description
HELP cmd (1 or 2) View more detailed help for the command cmd
2ACCESS (1 or 2) Change to Access Level 2
ACCESS (1 or 2) Change to Access Level 1
ANA p t (2) Output an analog value of p% for t minutes (1 - 10)
ANA R t (2) Ramp the analog output over t minutes (1 - 10)
CONTROL n (2) Set, clear, or pulse Relay Word bit RBn (1 - 4)
DATE (1 or 2) View or change the date
EVENT n (1 or 2) View full-length event report n (1 - 14)
HISTORY (1 or 2) View the event summary reports
HISTORY R (2) Reset the event buffer
LDP (1 or 2) View load profile data
LDP D (1 or 2) View load profile buffer size, days remaining
LDP R (2) Reset load profile data
METER (1 or 2) View/reset relay measured quantities
MOTOR (1 or 2) View the motor operating statistics
MOTOR R (2) Reset the motor operating statistics
MSR n (1 or 2) View motor start report n (1 - 5)
MST (1 or 2) View motor start trending data
MST R (2) Reset the motor start trend data
PASSWORD (2) View/change the relay passwords
PULSE n k (2) Pulse output contact n for k minutes (1 - 30)
QUIT (1 or 2) Change to Access Level 1
RLP (2) Reset learned motor parameters
SER (1 or 2) View sequential events records
SER R (2) Reset the sequential events buffer
SET (2) Set the relay
SHOW (1 or 2) View the relay settings
STATUS (1 or 2) View the relay self-test status
STATUS R (2) Reset relay self-test warning or failure
STOP (2) Stop the motor
STR (2) Start the motor
TARGET (1 or 2) View the status of relay elements, inputs, or outputs
TARGET R (1 or 2) Reset trip/target LEDs
TIME (1 or 2) View or change the time
TRIGGER (1 or 2) Trigger an event report
=>
Figure 6.3 HELP Command Response.