Date Code 20010719 701 Motor Protection Relay
Manual Change Information
The date code at the bottom of each page reflects the most recent release date of this
manual. With each release, the table of contents, list of tables, list of figures, list of
equations, list of examples, and index are updated. Changes in this manual since its
initial release are summarized in the table below (most recent releases listed at the top).
Release Date Summary of Changes in this Release
This Manual Change Information section is provided as a record of changes made to
this manual since the initial release.
20010719 Date of Fifth Release. Changes made:
Replaced Standard Product Warranty page with warranty
statement on cover page.
Updated Firmware Upgrade Instructions (Section 10).
20010223 Date of Fourth Release. Changes made:
New firmware release information (Appendix A).
20001102 Date of Third Release. Changes made:
Functional description diagram added (Section 1).
Specifications updated; section name changed from
Detailed Specifications to Specifications (Section 1).
SEL-701PC Software features updated (Section 3).
Thermal model settings updated (Section 4, Appendix F).
Load-loss settings updated (Section 4, Appendix F).
Contact input IN7 shown on SEL-2600 RTD Module
(Section 4).
Nickel 100 RTD resistance in Table 4.26 updated to DIN
43760 (Section 4).
Display message settings five and six added (Section 4,
Section 9, Appendix B, Appendix F).
TARR SEL
OGIC control equation added (Appendix B).
Recommended data download schedule added (Section 10).
Date/time section from Modbus deleted (Appendix C).
Stopped threshold to 10% of Full Load Amps revised
(Section 9, Appendix B).
List of possible trip types displayed in the history report
expanded (Section 9).
Event type strings corrected (Appendix C).
To Next Page
Loading...
