A.5
Date Code 20090730 Instruction Manual SEL-734 Meter
Firmware and Manual Versions
Firmware
Form 5 Meter
SEL-734-R516-V0-Z005001-D20060131
Form 9 Meter
SEL-734-R116-V0-Z005001-D20060131
➤ Manual update only—see Tab l e A.2 for a summary of
manual changes.
20060420
Form 5 Meter
SEL-734-R516-V0-Z005001-D20060131
Form 9 Meter
SEL-734-R116-V0-Z005001-D20060131
➤ Corrected modem disconnect/VSSI conflict. 20060131
Form 5 Meter
SEL-734-R515-V0-Z005001-D20051118
Form 9 Meter
SEL-734-R115-V0-Z005001-D20051118
➤ Correct synchrophasor dropped packets.
➤ Saving Port 1 settings always restarts meter.
20051118
Form 5 Meter
SEL-734-R514-V0-Z005001-D20051027
Form 9 Meter
SEL-734-R114-V0-Z005001-D20051027
➤ Prevented possibility of meter disabling after a settings change.
➤ Ensured synchrophasor feature always responds to enable messages.
20051027
Form 5 Meter
SEL-734-R513-V0-Z005001-D20051003
Form 9 Meter
SEL-734-R113-V0-Z005001-D20051003
➤ Corrected contact input response to ac voltage. 20051003
Form 5 Meter
SEL-734-R512-V0-Z005001-D20050817
Form 9 Meter
SEL-734-R112-V0-Z005001-D20050817
➤ Added Meter Gain Adjustment settings.
➤ Increased the range of the SET E command.
➤ Corrected Compressed Event Report header format error.
➤ Enhanced Configurable Display Points.
➤ Added signed VAR through Modbus.
➤ Enhanced SEL-5601 support of Raw Event Report.
➤ Allow field change of Meter form.
➤ Added multiple, simultaneous Modbus TCP/Telnet sessions.
➤ Added additional energy registers to Modbus map.
➤ Added Quadrant Bits to Meter Word bits.
➤ Corrected VAR quadrant accumulation error when at zero Power
Factor.
➤ Added support for COMTRADE-formatted Event Reports.
20050817
Form 5 Meter
SEL-734-R511-V0-Z004001-D20050617
Form 9 Meter
SEL-734-R111-V0-Z004001-D20050617
➤ Corrected possible error condition when reading event reports. 20050617
Table A.1 Firmware Revision History (Sheet 5 of 7)
Firmware Identification (FID) Number Summary of Revisions
Manual
Date Code
Courtesy of NationalSwitchgear.com
To Next Page
Loading...
