Figure 116: SOAPS ET – Activating cross beam measuring mode
b
Select the measuring function.
✓
The following dialog box will open: Warning. Activating this function will increase the num‐
ber of beams. All beam-dependent settings must be adjusted accordingly.
Figure 117: SOAPS ET, beam window – “Cross beam measuring” display
b
Click Yes to activate the Cross beam measuring mode. Click No to cancel.
✓
The light grid display is adjusted in the middle section (beam window). The real
and virtual beams are renumbered and, as a result, the number of beams is
nearly doubled. The virtual beams are displayed as dashed lines.
b
Check the existing configuration for the “Cross beam measuring” function.
b
Adjust the configuration for the “Cross beam measuring” function accordingly.
7
CONFIGURATION WITH SOPAS ET
98
O P E R A T I N G I N S T R U C T I O N S | MLG-2 Pro 8017460.ZIK1/2017-02-13 | SICK
Subject to change without notice
To Next Page
Loading...
