inst_h3.fm
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
4-85
Nur für den internen Gebrauch Installing HiPath 3000
Installing HiPath 3550, HiPath 3350, HiPath 3500, and HiPath 3300
4.2 Installing HiPath 3550, HiPath 3350, HiPath 3500, and HiPath 3300
4.2.1 Installation Prerequisites
Tools and resources needed
The following are needed for installing the HiPath 3550, HiPath 3350, HiPath 3500, and HiPath
3300 systems:
● Tools:
– Diagonal cutting pliers, telephone pliers, wire stripper, flat-nosed pliers
– Slotted screwdrivers, from 2 to 8 mm (1/4 to 5/16 in.)
– Phillips or cross-point screwdrivers, sizes 1 and 2
– TORX screwdriver
– Electric drill, hammer
– Level, tape measure
– For U.S. only: Punch-down tool suitable for the block used (such as block 66)
● Resources:
– Assistant T or HiPath 3000/5000 Manager E
– Digital multimeter for testing ground connections and partial voltages
– Telephone test set for analog interfaces
– Not for U.S.: ISDN tester (such as K3000 or Aurora)
– For U.S. only: Aurora
Duet
, Aurora
Expert,
Aurora
Remote
or similar, ISDN protocol analyz-
er
7
Warning
Only authorized service personnel should install and start up the system.
To Next Page
Loading...
Need help?
General