10
03/2006
10.9 Automatic controller settings ( HMI Advanced only)
10-222
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
End
3
Do you want to back up the
boot file for drive X and
display the modified
controller data?
SK “Yes”
SK “No”
Boot file is not
saved
Start
measurement of
speed controller?
SK “OK”
Prompt to press NC-Start
Warning:
Pressing NC-Start causes the axis
to perform a traversing motion.
SK “Parameter”
Enter the
measuring
parameters
SK “Abort”
(discard
changes)
SK “OK”
(accept
values)
Boot file is
saved
3
10 Drive O
timization
To Next Page
Loading...
