11
03/2006
11.6 Data back-up via V24
11-238
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
The sequence of operations for outputting data via the V24 interface applies to
all data. Proceed as follows:
1. Place the cursor on the required data.
2. Press the “Data out” soft key.
3. Press the “V24” or “PG” soft key.
4. Press the “OK” soft key.
5. Read the error log if errors occur while outputting the data.
When backing up data via RS-232 it is not advisable to save all the directories.
Only the data required from re-commissioning are to be output. Use a streamer
for a full back-up of all data.
Outputting data
What do you want
to save?
11 Data Back-U
To Next Page
Loading...
