03/2006
iv
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
If you have any questions, please contact the following hotline:
Europe and Africa time zones:
A&D Technical Support
Tel.: +49 (0) 180 / 5050 – 222
Fax: +49 (0) 180 / 5050 – 223
Internet: http://www.siemens.com/automation/support-request
E-Mail: mailto:adsupport@siemens.com
Asia and Australia time zones:
A&D Technical Support
Tel.: +86 1064 719 990
Fax: +86 1064 747 474
Internet: http://www.siemens.com/automation/support-request
E-Mail: mailto:adsupport@siemens.com
America time zone:
A&D Technical Support
Tel.: +1 423 262 2522
Fax: +1 423 262 2289
Internet: http://www.siemens.com/automation/support-request
E-Mail: mailto:adsupport@siemens.com
Note
Country-specific telephone numbers for technical advice can be found on the
Internet:
http://www.siemens.com/automation/service&support
If you have any questions about the documentation (suggestions or correc-
tions), please send a fax or e-mail to the following address:
Fax: +49 (0) 9131 / 98 – 63315
E-Mail: mailto:motioncontrol.docu@siemens.com
Fax form: see Feedback sheet at the end of this document.
http://www.siemens.com/sinumerik
The EU Declaration of Conformity about the EMC Directive can be found/
obtained
S on the Internet:
http://www.ad.siemens.com/csinfo
under product/order number 15257461
S from the responsible branch of the A&D MC Division of Siemens AG
The publication illustrates the structure of the control system and the interfaces
to the individual components. It also describes the procedure for starting up
SINUMERIK 810D, and lists all the data, signals and PLC modules.
Technical Support
Questions about
this Guide
SINUMERIK
web site
EU Declaration of
Conformity
Object of the book
Preface
To Next Page
Loading...
Need help?
General
