03/2006
v
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
User-oriented activities such as the creation of part programs and control
operation procedures are described in detail in separate documents.
Separate descriptions are likewise provided for the tasks to be performed by the
tool manufacturer such as configuring, installation and PLC programming.
This manual contains instructions that you must follow to ensure your own per-
sonal safety and to avoid damage to property. The instructions that concern
your personal safety are indicated by a warning triangle. Instructions that con-
cern only damage to property have no warning triangle. The warnings labels are
illustrated in descending order according to the level of risk.
!
Danger
means that death or severe injury will occur if the specified precautionary
measures are not taken.
!
Warning
means that death or severe injury may occur if the specified precautionary
measures are not taken.
!
Caution
with warning triangle means that slight injury may occur if the specified precau-
tionary measures are not taken.
Caution
without a warning triangle means that damage to property may occur if the
specified precautionary measures are not taken.
Notice
means that an unwanted result or state may occur if the specified instructions
are not followed.
If several levels of risk apply, the warning instructions always indicate the
highest level. If a warning of personal injury is given in a warning notice with the
warning triangle, there may also be a warning about damage to property in the
same warning notice.
Safety instructions
Preface
To Next Page
Loading...
Need help?
General
