Sirona DAC UNIVERSAL - Display messages DAC UNIVERSAL STANDARD

60 53 362 D3472
D3472.201.10.20.02 07.2016
211
Sirona Dental A/S 10Display messages DAC UNIVERSAL STANDARD
Operating Instructions DAC UNIVERSAL
båÖäáëÜ
10
Display messages DAC UNIVERSAL
STANDARD
Any errors that cannot be immediately recognized by the user but must
be remedied are displayed on the DAC UNIVERSAL display. These error
messages are indicated with a code. The display does not show any plain
text error output.
Reset display messages
WARNING
When the DAC UNIVERSAL shows a display message, a complete
cycle may not have been conducted. The instruments are thus
considered non-sterile and must be reprocessed again.
CAUTION
Danger of burning!
Hot steam may emerge from the chamber.
➢ Please do not open the DAC UNIVERSAL when the temperature is
still above 104°C (219°F), see display indicator.
IMPORTANT
If the DAC UNIVERSAL shows the same display message more than
once, and this is not due to lack of consumables, please contact your
authorized dealer.
IMPORTANT
When an error is encountered, an alarm will sound and the display
message will appear in the display.
➢ Please note the message before resetting the alarm.
➢ Press on the "Clear"-Key to reset the alarm and delete the
message.
 When the "Clear"-Key is pressed, the lid is raised for approx. 2
seconds. The lid stops here until the temperature drops to less than
104°C / 219°F. Then it opens completely.
IMPORTANT
If a message is displayed during sterilization, it is shown again when the
lid opens. To delete this error message and start a new cycle, you must
press the "Menu/Enter"-Key and the "Clear"-Key simultaneously. This is
indicated on the display.