Sirona DAC UNIVERSAL - Operation DAC UNIVERSAL ADVANCED; Regular activities

60 53 362 D3472
D3472.201.10.20.02 07.2016
59
Sirona Dental A/S 5Operation DAC UNIVERSAL ADVANCED
Operating Instructions DAC UNIVERSAL 5.1Regular activities
båÖäáëÜ
5
Operation DAC UNIVERSAL ADVANCED
5.1
Regular activities
Introducti on regular activiti es
The DAC UNIVERSAL was installed by a service technician according to
the instructions in the "Installation [ → 49]" section.
See below for an overview of the activities that must be conducted during
the regular use of the DAC UNIVERSAL.
5.1.1 Pre- and post-reprocessing of instruments
5.1.2 Checking the reprocessing result with an indicator / PCD
test device
Installation / major repairs: Before using the DAC UNIVERSAL after installation or larger repairs, we
recommend checking the sterilization result using a Class 5 chemical
indicator and/or a PCD test device.
Activities and relevant chapter in the Operating Instructions
„Pre- and post-reprocessing of instruments [ → 59]“
„Checking the reprocessing result with an indicator / PCD test device
[ → 59]“
Replacing the lubrication concentrate, see "Adding/replacing the
lubrication concentrate [ → 66]"
„Checking oil supply to the chamber of the DAC UNIVERSAL
ADVANCED [ → 122]“
„Filling the water tank [ → 69]“
"Checking water supply to the chamber of the DAC UNIVERSAL
ADVANCED [ → 122]"
IMPORTANT
Please follow the regulations and guidelines applicable in your country
in your practice.
IMPORTANT
Please follow the instrument manufacturer's instructions when handling
the instruments.
IMPORTANT
The chuck of the instruments must be lubricated regularly after a
mechanical cleaning according to the requirements of the instrument
manufacturer.
If possible let oil remain over night in the instrument and run a cycle later
in the DAC UNIVERSAL.
IMPORTANT
Please follow the regulations and guidelines applicable in your country
in your practice.