Sirona DAC UNIVERSAL - Standard settings and Resetting the menu system DAC UNIVERSAL STANDARD

60 53 362 D3472
D3472.201.10.20.02 07.2016
169
Sirona Dental A/S 8Operation DAC UNIVERSAL STANDARD
Operating Instructions DAC UNIVERSAL 8.2Using the menu and display information DAC UNIVERSAL STANDARD
båÖäáëÜ
8.2.3 Standard settings and Resetting the menu system DAC
UNIVERSAL STANDARD
Standard settings
Only for Japan: ambient temperature sensitivity is set at 4. Please note
this when resetting the menu to standard settings the ambient
temperature sensitivity will be set to 1.
Resetting the menu system
To reset the menu to the default settings, please proceed as follows:
✔ The display shows the status "Ready 134 °C" .
➢ Press the "Wrapped"-Key and the "Menu/Enter"-Key simultaneously.
 The properties in your menu are reset to the default settings, see
"Menu overview DAC UNIVERSAL STANDARD [ → 166]".
8.2.4 Omitting parts of cycles DAC UNIVERSAL STANDARD
It is possible to leave out parts of cycles. This is necessary for
reprocessing wrapped or solid instruments, for example.
After ending a cycle in which some parts of the cycle were deactivated,
the DAC UNIVERSAL automatically reactivates the standard program.
Program 134°C / 273°F, Sterilization time 3 min.
Printer: Off
Language: UK
Oil purge: 1
Oil settings: 1
Rinse cycles: 4
Expel: 0
Ambient temperature
sensitivity:
1
Automatic water: Off
IMPORTANT
Sterilization cannot be omitted.